Chemlease One FS EZ脱模剂
Chemlease One FS EZ是一种用于复合材料行业的无HAP溶剂半永久释放剂，可一步轻松应用。应将Chemlease One FS EZ轻轻地涂抹在模具表面，并使其干燥。一旦Chemlease One FS EZ干燥，就会重现原来的模具表面光洁度外观。
Chemlease One FS EZ is a HAP’s-free solvent-based semi-permanent releasant for the composites industry which affords easy application in one step. The product should be applied to the mold surface very lightly and allowed to dry. The original mold surface finish appearance will be reproduced once the product is dry.
Application - Wipe-on method
1. The mold surface must be cleaned to remove all traces of wax, release agents, and other sealers before application of Chemlease® One FS EZ can be attempted. Use the appropriate Chemlease® Mold Cleaner (Contact your Chemlease Sales Representative for a recommendation).
2. Apply a light, even coat to the mold surface. As a guide to achieving a "light coat" when the film is applied to a VERTICAL mold surface, the wet film
should shine, but there should be no runs in it. Runs in the film indicate too heavy an application.
3. As soon as the wiping action appears not to be forming a film, add more product to the cloth as describe above in step #2.
4. Continue working across the mold until its entire surface has been coated.
5. Allow the film to dry for 15 minutes.
6. Using the same procedure, apply 5 complete coats. For a new mold or difficult to release part, apply an additional 2 coats for a total of 7 coats.
7. Cure for a minimum of 30 minutes after the final coat has been applied.
8. Begin molding and continue until release-ease appears tight.
9. When release becomes difficult reapply 1 coat of Chemlease® One FS EZ. Allow to cure for 15 minutes and resume molding.
